Lectrosonics ALP 650 Antenna UHF, log periodic, amplified

Lectrosonics ALP 650 Antenna UHF, log periodic, amplified
Pre Order

Price: 821,00€ + VAT
Price (VAT included): 1.001,62€


Model: [LTALP650]
Manutacturer: Lectrosonics

Contact us:

Rated 4.38/5 (8 Votes)



Lectrosonics ALP650 "Shark Fin" Broad Band Directional Antenna.

The ALP Series antennas are a Log Periodic Dipole Array (LPDA) design that provides a useful directional pattern over a broad frequency bandwidth. Most “gain antennas” (those designs with a directional pattern) are limited in bandwidth. This makes them awkward for use in multi-channel wireless systems and with frequency agile wireless systems.

With SWR below 2:1 from 400-700 MHz, the broad bandwidth of the ALP650L/E covers the entire UHF band used for Lectrosonics wireless microphone and IFB systems, yet still provides the directional pattern needed to cover long distances.

All ALP Series antennas are constructed of 1/8” FR4 fiberglass board and are extremely rugged. The ALP620 and ALP650 antennas are best suited for portable applications including temporary setups for field shoots, while the more economical ALP500 is well-suited for more permanent indoor installation. Additionally, the perforated design of the ALP620 makes it highly resistant to wind loading. None of the antennas in the ALP Series are intended to be left outdoors indefinitely. A sturdy aluminum housing protects the 50 Ohm BNC connector on the ALP620 and ALP650 models.

An optional adapter kit is available for all three models that provides a variety of mounting options with the mounting block. The antennas can be mounted on horizontal or vertical surfaces by removing four screws and repositioning the mounting block. This helps to optimize the mounting away from nearby surfaces to reduce the effect of reflections and preserve more of the natural pattern of the antenna design.
Specifications: RF Amplifier (ALP650 only) Third Order Intercept: +27 dBm @ input (+41 dBm output)
Filter Bandwidth: 230.0 MHz, factory set.
RF Gain: +12 dB with 0dB attenuator
+8 dB with 4dB attenuator
+5 dB with 7dB attenuator
Power Requirements: 8V to 16V DC at the input jack; auto reset poly fuse protection circuit; constant power switching supply
• 8V DC (125 to 145 mA)
• 12V DC (83 to 106 mA)
• 14.4V DC (69 to 89 mA)
• 16V DC (60 to 80 mA)
Phantom Powering: DC voltage supplied via coaxial cable by UMC16B or VRM input jack or BIAS-T power inserter (70 to 80 mA)
Power Consumption: 1 Watt nominal (switching regulator)

Range: 400-700 MHz
Weight: 15.6 ozs
Connector: 50 Ohm BNC
Dimensions: 13.5” L x 12.25” W

 


For more information, please visit this products webpage.