Remote Audio BDSv4 output cables

Mod:[RABDSC] Prod: Remote Audio
AvailablePrice: 26,00€ + VAT
Back   E-mail   Skype Us   Print  
BDSCLSR Cavo d'uscita, da LZR 90° con ghiera di fissaggio a LZR diritto con ghiera di fissaggio (positivo centrale).
Per ricevitori SR/SRA Lectrosonics e Battery Eliminator dei trasmettitori SMA Lectrosonics. 60cm. Vedi foto n. 1.
Prezzo euro 38,00 + IVA.


BDSCL33 Cavo d'uscita standard, da LZR 90° con ghiera di fissaggio a LZR 90° (positivo centrale).
Per Lectrosonics IFBT1, serie 100, 200 e 400 BattElim, PSC DV Promix3, Shure FP32A, FP33 e altri. 60 cm. Vedi foto n. 2.
Prezzo euro 26,00 + IVA.

BDSCL33Y Cavo d'uscita a "Y", da LZR diritto con ghiera di fissaggio a 2 LZR 90° (positivo centrale).
Per Lectrosonics IFBT1, serie 100, 200 e 400 BattElim, PSC DV Promix3, Shure FP32A, FP33 e altri. 60 cm. Vedi foto n. 3.
Prezzo euro 44,00 + IVA.


BDSCSQN Cavo d'uscita, da LZR 90° con ghiera di fissaggio a Hirose 4 pin.
Per Lectrosonics Quadpack; Sound Devices 552, 788T, 744T, 722, 702, 302, Mix-Pre-D; PSC DV Promix6, Alphamix; SQN-4S, 60cm. Vedi foto n. 4.
Prezzo euro 46,00 + IVA.


BDSUSB Cavo d'uscita, da LZR 90° con ghiera di fissaggio a porta USB.
Ottimizzato per apparati Apple, 60cm. vedi foto 5.
Prezzo euro 36,00 + IVA.


Description
The outlet connectors on the BDS box are a special switching type that requires a long-shaft mating plug with a 2.5mm hole. This connector set was chosen for its strength and so that unused (exposed) outlets on the box are not active until a cable with the proper mating connector is plugged into it, helping prevent accidental short circuits. Output cables by Remote Audio are manufactured specifically for use with the BDS, and come with unique low-profile right angle locking connectors. Therefore, it is recommended that only Remote Audio brand output cables be used with the BDS system. The polarity of the outlets is "center positive". "Y" cables are available for connecting more than six devices. Input cables, battery adapters and AC-DC adapters by Remote Audio are also available. The input connector on the BDS box is a common TA4M (miniature 4-pin male XLR) with the standard scheme of "pin-1 NEG, pin-4 POS". To improve reliability and reduce voltage drop, the contacts are doubled 1-2 and 3-4 at the circuit board. Therefore, if the user wires their own input cables, it is recommended to connect pins 1-2 and 3-4. The power indicator built into the BDS box switch can be used to confirm proper polarity of the input cable (if it illuminates, the polarity is correct).
 

For more information, please visit this products webpage.

Rated 4.75/5 (4 Votes)